Resultado da Busca
Queues are used to limit and prioritize traffic: limit data rate for certain IP addresses, subnets, protocols, ports, and other parameters. limit peer-to-peer traffic. prioritize some packet flows over others. configure traffic bursts for faster web browsing. apply different limits based on time.
The PPPoE (Point to Point Protocol over Ethernet) protocol provides extensive user management, network management and accounting benefits to ISPs and network administrators. Currently PPPoE is used mainly by ISPs to control client connections for xDSL and cable modems as well as plain Ethernet networks. PPPoE is an extension of the standard ...
PCC takes selected fields from IP header, and with the help of a hashing algorithm converts selected fields into 32-bit value. This value then is divided by a specified Denominator and the remainder then is compared to a specified Remainder, if equal then packet will be captured. You can choose from src-address, dst-address, src-port, dst-port ...
This manual provides an introduction to RouterOS built-in powerful scripting language. Scripting host provides a way to automate some router maintenance tasks by means of executing user-defined scripts bounded to some event occurrence. Scripts can be stored in Script repository or can be written directly to console .
Manual:Securing Your Router. The following steps are recommendation how to protect your router. We strongly suggest to keep default firewall, it can be patched by other rules that fullfils your setup requirements. Other tweaks and configuration options to harden your router's security are described later.
To manage IP addresses of the router open 'IP -> Address'. You will have one address here - address of your local area network (LAN) 192.168.88.1 one you are connected to router. Select Add new to add new static IP address to your router's configuration. You have to fill only fields that are marked.
How to reset configuration. 1) unplug the device from power. 2) press and hold the button right after applying power. Note: hold the button until LED will start flashing. 3) release the button to clear configuration. Note: If you wait until LED stops flashing, and only then release the button - this will instead launch Netinstall mode, to ...
