Resultado da Busca
Turn ignition switch “ON” (without starting vehicle) and wait at least 2 seconds. 5. Turn ignition switch “OFF” wait at least 10 seconds. “Throttle Valve Closed Position Learning” is an operation to learn the fully closed position of the throttle valve by monitorizing the throttle position sensor output signal.
Like many with the vq35hr, I've had the following issues that started presenting at about 90k with no CEL: 1. Stuttering/low idle/near stall/stall when stopped in gear. 2. Upon warm restart, engine idle would drop below 500 rpm and almost stall, 3. When cold, at light throttle input, a stumble/stutter around 1,700 rpm that almost felt like a ...
29 de out. de 2021 · Re: P0300 Random Multiple misfire. Post by VStar650CL » Sun Jul 10, 2022 4:14 pm. Voltage drop on the high side of the injector circuit can only come from the IPDM or the wiring. Note that the car must be running for all these tests, the circuit has to be loaded for voltage checks to mean anything: 1) Check both sides of F10:F120, if the F10 ...
22 de mai. de 2020 · Hi all, It's my first post here so go easy on me! I did a quick search and didn't find quite the same scenario I have. I have a 2011 Pathfinder and I noticed recently that the driver's side master switch for the windows works as intended on all but the rear driver side window. The master switch can put the driver rear window down, but not back up.
15 de out. de 2014 · Hello all, I'm hoping to get some guidance on an some issues I'm having with my 2002 Pathfinder. 1st off we were driving home from a camping trip and the CEL started to flash and the engine was shaking pretty bad, when we got home I pulled the plug on cylinder # 3 (as this is where the misfire was according to the ODBII) and noticed that the spark plug
7 de dez. de 2011 · Remove the two screws that are connecting the center console to the thermostat trim. 4. On the drivers side, pull the side of the center console away from dash trim. 5. Put e-brake on and shift into drive. Next to the shifter there is a little plastic tab. Pop it out and place a screwdriver in there.
Learn more about Nissan Pathfinder at the Edmunds.com Car Forums! Read real discussions on thousands of topics and get your questions answered.
In my case the P0306 Cylinder 6 Misfire Detected. Turned out to be the fuel pressure regulator. It's vacuum supply hose originates right above cylinder #6. When the fuel pressure regulator diaphragm failed, raw fuel traveled up the vacuum hose and flooded out the #6 cylinder. This was after a good compression test and new wires and spark plugs.
Repeat the following steps (2a and 2b) procedures quickly five times within 5 seconds. 2-a. Fully depress the accelerator pedal (HARD).2-b. Fully release the accelerator pedal. 3. Wait 7 seconds, fully depress the accelerator pedal and keep it for approximately 10 seconds until SERVICE ENGINE SOON starts blinking. 4.
27 de jul. de 2009 · I think I have a similar issue with my 2002 Pathfinder. The driver side headlight only works with HighBeams, whereas the passenger side only works LowBeam. I swapped the lightbulbs themselves, and that didn't change anything so its not the bulbs. From reading through this post, it appears its likely the Control module.
