Resultado da Busca
6 de fev. de 2010 · /routing ospf network add network=10.1.1.0/24 /routing ospf interface add interface=ether1 add interface=all passive=yes Nothing complicated. <- Smart Ass Regards, Maris-----Hello, If OSPF is not seeing neighbors after setting interfaces to passive, it means that you set passive interface which shouldn't be passive. Send us supout file from the ...
Summary. MikroTik RouterOS implements OSPF version 2 (RFC 2328). The OSPF protocol is the link-state protocol that takes care of the routes in the dynamic network structure that can employ different paths to its subnetworks. It always chooses shortest path to the subnetwork first.
This manual introduces you with commands which are used to perform the following functions: system configuration reset. The configuration backup can be used for backing up MikroTik RouterOS configuration to a binary file, which can be stored on the router or downloaded from it using FTP for future use. The configuration restore can be used for ...
For example, on R5 OSPF is configured with the following commands: /routing ospf instance set redistribute-connected=as-type-1 /routing ospf network add area=backbone network=4.4.4.0/24 /routing ospf network add area=backbone network=5.5.5.0/24 On other routers OSPF is configured in similar way. This yields routing table on R5 like this:
For static routing, the basic principles of IPv6 are exactly the same as for IPv4 . Simple ipv6 routing example: 0 A S dst-address=2001::/16 gateway=fc00:dead:beef::2 reachable ether1 distance=1. scope=30 target-scope=10. Most notable difference between ipv4 and ipv6 is that link local addresses can be used as route nexthops if interface is ...
13 de mai. de 2009 · Two routers do not become neighbors unless the following conditions are met. Two way communication between routers is possible. Determined by flooding Hello packets. Interface should belong to the same area; Interface should belong to the same subnet and have the same network mask, unless it has network-type configured as point-to-point;
As result user is able to control what features are available and size of installation. Packages are provided only by MikroTik and no 3rd parties are allowed to make them. Acquiring packages. Packages can be downloaded from MikroTik download page or mirrors listed on that page.
