Resultado da Busca
In this setup we will be connecting a PTP configuration using a Dual Setup and OSPF ( Open Shortest Path First ). The requirements for this set up is to have a board that supports at least 02 radios. If you would like to double the bandwidth and redundancy, take a look at this Tutorial with Dual Radios. The advantages for this setup are:
Manual:OSPFv3 with Quagga. In this example we demonstrate interoperability of MikroTik 3.x with Quagga in multi-area OSPF setup with load balancing. RouterOS version 3.16 and Quagga 0.99.11 are used respectively.
/ip address add address=10.7.7.1/24 interface=backlink /routing ospf network add area=backbone network=10.7.7.0/24 /routing ospf interface add interface=backlink cost=1000 network-type=point-to-point CE2 additional backlink
Wen this parameter is not set, OSPF will try to get it from configured IPv4 addresses, if IPv4 address are missing process will fail and OSPF will not work. At this point both LAN segments can reach Ipv6 Global network routed over 6to4 tunnel.
1 de ago. de 2009 · Then LDP distributes MPLS labels for existing routes. Note that OSPF (in case you use it) has nothing to do with MPLS - it simply distributes routes. MPLS switching along existing routes is ensured by LDP. BGP is necessary to exchange routes in VRFs (so called VPNv4 routes) between PEs. BGP is required only between PEs.
From MikroTik Wiki. Jump to navigation Jump to search. Welcome to the MikroTik documentation wiki. Note: Our new documentation site can be found here: ...
Category:Manual. This page contains only official articles written by MikroTik, grouped by topic, and also alphabetically. Table of Content. Table of Content sorted by RouterOS Menus. Note: below alphabetical list can contain articles that are not written by Mikrotik but are added to this category, as it is generated automatically from list of ...
