Resultado da Busca
In this setup we will be connecting a PTP configuration using a Dual Setup and OSPF ( Open Shortest Path First ). The requirements for this set up is to have a board that supports at least 02 radios. If you would like to double the bandwidth and redundancy, take a look at this Tutorial with Dual Radios. The advantages for this setup are:
Virtual Routing and Forwarding. Route Selection Algorithm in RouterOS. OSPF Forwarding Address. Internet access from VRF with NAT. EBGP as PE-CE routing protocol. Creating IPv6 loopback address. OSPFv3 with Quagga. BGP Load Balancing with two interfaces. BGP based VPLS.
This example explains how to use multiple gateways with one taking over when first fails. It begins with adding the gateways. Set bigger distance value for the secondary one, and check-gateway for the first one: /ip route add gateway=192.168.1.1 check-gateway=ping. /ip route add gateway=192.168.2.1 distance=2. That's all, there are no more steps!
IPv6 overview. Internet Protocol version 6 (IPv6) is the new version of the Internet Protocol (IP). It was initially expected to replace IPv4 in short enough time, but for now it seems that these two version will coexist in Internet in foreseeable future. Nevertheless, IPv6 becomes more important, as the date of unallocated IPv4 address pool's ...
Материал из MikroTik Wiki OSPF (Open Shortest Path First) — протокол динамической маршрутизации, основанный на технологии отслеживания состояния канала (link-state technology) и использующий для нахождения кратчайшего пути алгоритм Дейкстры.
Summary. MikroTik RouterOS implements OSPF version 2 (RFC 2328). The OSPF protocol is the link-state protocol that takes care of the routes in the dynamic network structure that can employ different paths to its subnetworks. It always chooses shortest path to the subnetwork first.
From MikroTik Wiki. Jump to navigation Jump to search. Welcome to the MikroTik documentation wiki. Note: Our new documentation site can be found here: ...
