Resultado da Busca
ProCuity’s intuitive touchscreen displays bed monitoring notifications when the bed configuration is out of compliance with the parameters set at the bedside. It also displays smart prompts – helpful reminders such as to zero the bed before a new patient, and to re-arm the bed alarm when the bed senses the patient’s weight.
Page 12 120 VAC, 60 Hz, 8A Battery voltage 12 VDC, 1.2 Ah (x2) (Stryker part number: 700000341245) N N o o t t e e - - Always replace with Stryker approved batteries. Duty cycle 2 minutes ON, 18 minutes OFF Application environments...
To prevent a low battery condition when the bed is not plugged in, position the cord out switch at the head end of the bed to the off position. The switch is identified by the label shown below. If the switch is not posi-tioned as shown below and the bed power cord and pendant cord are unplugged, the life of the back– up bat-
Designed with interoperability in mind, it allows bed data – such as bed configuration and bed exit alarm activity – to be sent remotely to any of our iBed applications or any of the Hospital Information Systems (HIS) in your facility.4 Secure® ConnectTM New smart technology immediately enables a cable-less nurse call solution when the bed
4 de fev. de 2021 · KALAMAZOO, Michigan, USA, Feb. 4, 2021 /PRNewswire/ -- Stryker, one of the world's leading medical technology companies, announced its EMEA launch of a completely wireless hospital bed, ProCuity ...
21 de out. de 2020 · ProCuity Bed Series designed to enhance patient and caregiver safety for all acuity levels, reduce in-hospital falls. Stryker has announced the global launch of the industry’s first and only completely wireless hospital bed, ProCuity. This intelligent bed was designed to help reduce in-hospital patient falls at all acuity levels, improve ...
of the bed needing service. 4. Press down on the release pedal for the end of the bed you are working on and, at the same time, push down on the jack actuator until it is fully down. 5. Using a #2 Phillips screwdriver, remove the three Phillips screws holding the base hood to the base frame. 6.
