Resultado da Busca
RouterOS 3.x allows to create multiple Virtual Routing and Forwarding instances on a single router. This is useful for BGP based MPLS VPNs. Unlike BGP VPLS, which is OSI Layer 2 technology, BGP VRF VPNs work in Layer 3 and as such exchange IP prefixes between routers. VRFs solve the problem of overlapping IP prefixes, and provide the required ...
Many MikroTik devices come with a built-in switch chips that usually have an option to do VLAN switching on a hardware level, this means that you can achieve wire-speed performance using VLANs if a proper configuration method is used. The configuration method changes across different models, this guide will focus on setting up a basic trunk ...
add address=192.168.88.1/24 interface=bridge1. It is required to add VLAN 1 to ports from which you want to allow the access to the router/switch, for example, to allow access from access ports ether3, ether4 add this entry to the VLAN table: /interface bridge vlan. add bridge=bridge1 untagged=ether3,ether4 vlan-ids=1.
Virtual Local Area Network (VLAN) is a Layer 2 method that allows multiple Virtual LANs on a single physical interface (ethernet, wireless, etc.), giving the ability to segregate LANs efficiently. You can use MikroTik RouterOS (as well as Cisco IOS, Linux and other router systems) to mark these packets as well as to accept and route marked ones.
Режим Hot Lock. С помощью клавиши F7 в консоли MikroTik RouterOS активируется режим Hot Lock в котором команды автоматически дополняются до полного написания как только будет введен уникальный набор ...
How to reset configuration. 1) unplug the device from power. 2) press and hold the button right after applying power. Note: hold the button until LED will start flashing. 3) release the button to clear configuration. Note: If you wait until LED stops flashing, and only then release the button - this will instead launch Netinstall mode, to ...
Description. IPv4 FastTrack handler is automatically used for marked connections. Use firewall action "fasttrack-connection" to mark connections for FastTrack. Currently only TCP and UDP connections can be actually FastTracked (even though any connection can be marked for FastTrack). IPv4 FastTrack handler supports NAT (SNAT, DNAT or both).
